Main Content

The CMOS sensor module features Aptina® MT9M111 SXGA-format single-chip camera with a 1/3-inch CMOS active-pixel digital image sensor. This device combines the MT9M011 image sensor core with fourth-generation digital image flow processor technology from Aptina Imaging. It captures high-quality color images at SXGA resolution.

The MT9M111 features DigitalClarity™, Aptina’s breakthrough, low-noise CMOS imaging technology that achieves CCD image quality (based on signal-to-noise ratio and low-light sensitivity) while maintaining the inherent size, cost and integration advantages of CMOS. It incorporates sophisticated camera functions on-chip and is programmable through a simple two-wire serial interface.

The MT9M111 performs sophisticated processing functions including color recovery, color correction, sharpening, programmable gamma correction, auto black reference clamping, auto exposure, automatic 50Hz/60Hz flicker avoidance, lens shading correction, auto white balance (AWB) and on-the-fly defect identification and correction. Additional features include day/night mode configurations; special camera effects such as sepia tone and solarisation; and interpolation to arbitrary image size with continuous filtered zoom and pan. The device supports both Xenon and LED-type flash light sources in several snapshot modes.


  • Parallel data output
  • I2C for control interface
  • 1.3-mega pixel resolution
  • 1/3-inch optical format
  • 15 frames per second (fps) at 170mW, full resolution; 30fps at 90mW, VGA resolution
  • Superior light performance
  • On-chip, 10-bit analog-to-digital converter
Please Login To Review This Product
There are no project for this product.

CMOS Camera - MT9M111

Product Code: (H-ELC-SEN-MV-2)


in stock


PCB Size 30mm x 30mm
General Specifications
Input Clock Frequency 2MHz - 54MHz
On-board Crystal 54MHz
ADC 10 bit on-chip
Color Filter Array RGB Bayer color filters
Imaging Area 4.6mm x 3.7mm
Interface 8 bit Parallel Bus
Pixel Size 3.6µm x 3.6µm
Resolution 1280 x 1024
Power Supply
Phase Voltage 2.8V ±0.3V